Schneider Electric Altivar 32 Manuel d'installation télécharger pdf (Page 217)

Configuration Mode (ConF)

S1A28692 03/2010 217

MULTIMOTORS / MULTICONFIGURATIONS

Motor or configuration switching [MULTIMOTORS/CONFIG.] (MMC-)

The drive may contain up to 3 configurations, which can be saved using the

[FACTORY SETTINGS] (FCS-) menu, page 69.

Each of these configurations can be activated remotely, enabling adaptation to:

• 2 or 3 different motors or mechanisms (multimotor mode)

• 2 or 3 different configurations for a single motor (multiconfiguration mode)

The two switching modes cannot be combined.

Note: The following conditions MUST be observed:

• Switching may only take place when stopped (drive locked). If a switching request is sent during operation,

it will not be executed until the next stop.

• In the event of motor switching, the following additional conditions apply:

- When the motors are switched, the power and control terminals concerned must also be switched as

appropriate.

- The maximum power of the drive must not be exceeded by any of the motors.

• All the configurations to be switched must be set and saved in advance in the same hardware configuration,

this being the definitive configuration (option and communication cards). Failure to follow this instruction can

cause the drive to lock on an [Incorrect config.]

(CFF) state.

Menus and parameters switched in multimotor mode

• [SETTINGS] (SEt-)

• [MOTOR CONTROL] (drC-)

• [INPUTS / OUTPUTS CFG] (I_O-)

• [COMMAND] (CtL-)

• [APPLICATION FUNCT.] (Fun-) with the exception of the [MULTIMOTORS/CONFIG.] function (to be

configured once only)

• [FAULT MANAGEMENT] (FLt)

• [MY MENU]

• [USER CONFIG.]: The name of the configuration specified by the user in the

[FACTORY SETTINGS] (FCS-) menu

Menus and parameters switched in multiconfiguration mode

As in multimotor mode, except for the motor parameters that are common to the 3 configurations:

• Rated current

• Thermal current

• Rated voltage

• Rated frequency

• Rated speed

• Rated power

• IR compensation

• Slip compensation

• Synchronous motor parameters

• Type of thermal protection

• Thermal state

• The auto-tuning parameters and motor parameters that can be accessed in expert mode

• Type of motor control

Note: No other menus or parameters can be switched.

Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 318 319

Commentaires sur ces manuels

Pas de commentaire

Schneider Electric Altivar 32 Manuel d'installation Page 217

Commentaires sur ces manuels

Produits connexes et manuels pour Tournevis électriques Schneider Electric Altivar 32