Schneider Electric Magelis XBT GT Spécifications télécharger pdf (Page 63)

35010372 10/2010 63

Inserting Labels into the XBT GK

Graphical Representation of Correctly Inserting Labels into the XBT GH

The following describes the procedures of inserting insert labels into the XBT GH.

Step Action

1 Press the pre-cut insert label of your choice out of the insert label sheet.

2 Remove the XBT GK from any enclosures or mounts. Take the XBT GK and turn

it around so that you can see its rear panel. At the bottom two corners of the rear

panel, located directly behind the overlapping display, you will find the opening

for the insert label.

3 Insert the insert label cautiously into this opening (as shown in the above figure)

until the key symbols / text on the wide part of the insert labels have disappeared

and the wide part of the insert label is flush with the opening. There will be merely

the small flap of the insert label with the double arrow being visible outside the

unit.

4 Turn the XBT GK around and check the front that all symbols / text are clearly

visible at the keys. If the text / symbols are not clearly visible, insert the insert

label a bit further into the opening.

5 If the text / symbols are clearly visible on the front of the unit, take the small part

(with the double arrow sign) of the insert label that is still visible on the rear of the

unit and slide this flap into the slit. The flap should now be flush with the rear of

the unit.

If the insert label has not correctly been inserted into the XBT GK, the flap of the

insert label will be too long to fit into this slit.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 245 246

Pas de commentaire

Schneider Electric Magelis XBT GT Spécifications Page 63