Schneider Electric Magelis XBT GT Spécifications télécharger pdf (Page 232)

232 35010372 10/2010

Self Test List

Introduction

The XBT GT, XBT GK, and XBT GH units are equipped with a number of diagnostic

features that can be used to check the systems and the interfaces for any problems.

Self Test

From the Settings menu, touch the Offline tab and then the Self Test icon. Self

Test menu appears. See the Vijeo Designer online help for information on accessing

the Offline tab.

Self Tests

The following tests can be accessed from the Self Test menu.

Test Description

Char. Pattern Checks the characters in each font set available on the unit. Use this

test when characters (usually 2-byte characters) do not display

properly.

OK appears if operation is normal; NG appears if an error is detected.

Disp. Pattern Use this test when your drawings do not display properly.

Touch Panel Tests the touch panel cells. Each cell highlights when it’s pressed

during the test.

COM 1 Checks to make sure the serial port (RS-232C and RS-485) is working

properly.

To run the check, you may need to connect a loopback cable (see

below).

OK appears if operation is normal; NG appears if an error is detected.

COM 2

Video Memory Use this check to test the video memory (memory used for screen

display). Run this test when the screen does not display properly.

OK appears if operation is normal; NG appears if an error is detected.

1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 245 246

Pas de commentaire

Schneider Electric Magelis XBT GT Spécifications Page 232