Schneider Electric Magelis XBT GT Spécifications télécharger pdf (Page 169)

35010372 10/2010 169

3 Do not insert the joint of the installation gasket in the corner of the unit. Insert

the joint only in the straight sections of the groove at the bottom of the product.

If you insert the joint incorrectly, the joint will be pulled so that it may cause the

installation gasket to be torn.

4 Make sure the gasket is inserted into the panel bottom face as shown in the

following illustration:

WARNING

LOSS OF PANEL OR CABINET INGRESS PROTECTION RATING

z Insert the gasket correctly in the groove as described in this documentation.

z Do not stretch the gasket.

z Do not insert the gasket seam in groove corners.

z Only install the gasket seam in the straight section of the gasket groove at the

bottom of the unit.

z Be sure that the upper surface of the gasket protrudes approximately 2.0 mm

(0.08 in.) above the edge of the groove.

Failure to follow these instructions can result in death, serious injury, or

equipment damage.

Stage Description

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 245 246

Pas de commentaire

Schneider Electric Magelis XBT GT Spécifications Page 169