Schneider Electric Magelis XBT GT Spécifications télécharger pdf (Page 199)

35010372 10/2010 199

USB Data Transfer Cable (XBT ZG935) - USB Driver Installation

Important information

Follow the procedure described below to prevent damage to the cable connector or

the unit.

z Do not connect the USB data transfer cable until told to do so in the instructions.

z When connecting the USB data transfer cable to the PC or to the unit, insert the

cable’s connector at the correct 90° angle.

z When disconnecting the cable, make sure to hold the connector, not the cable

itself.

z If the cable is unplugged from the port designated during installation and

connected to a different port, the OS will not recognize the new port. Therefore,

make sure to always use the port designated during installation.

z If the installation does not complete successfully, restart the PC and quit all

resident applications before re-installing the software.

NOTE: Vijeo Designer must be installed before installing the USB driver.

Installation Procedure for Windows 2000, XP, and Vista

Step Action

1 Insert the Vijeo Designer Installation CD-ROM into your CD-ROM drive. The

Setup window for Vijeo Designer should open automatically. If not, at the

Windows Start menu, click Run and type x:\install.exe (where x is your CR-

ROM drive name).

2 In the install menu, select USB Driver.

3 Select the driver you want to install from the window that appears. For the

XBT ZG935 USB cable, select Install USB driver for XBTGT2000 Series and

higher.

4 A popup window appears stating the installation of the driver was successful.

5 Connect the USB cable to the computer. Windows should automatically detect

the cable and state that the device is now ready to use.

1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 245 246

Pas de commentaire

Schneider Electric Magelis XBT GT Spécifications Page 199