Schneider Electric Mupgrade Utility Guide d'installation télécharger pdf (Page 36)

Using the Configuration Wizard

975-0720-01-01 2–3

This manual is for use by qualified personnel only

Using the Configuration Wizard

1. Start the Configuration Wizard: On the Configure menu, click Configuration

Wizard.

Click I Understand and Accept after reading the message.

2. Select your desired Configuration method: Quick, Detailed or Multi-Cluster.

To determine which method to select, refer to the differences between the

three configuration methods in “About the Configuration Wizards” on

page 2–2.

Note: When commissioning a new system, the Quick System Configuration

Method is recommended.

WARNING

HAZARD OF PHYSICAL INJURY AND/OR UNEXPECTED OPERATION

Configuration screens contain settings that should only be adjusted by a

qualified installer aware of the effects that the changes will have. Incorrect

settings could lead to increased shock or fire hazard, and risk of damage to

the inverter, batteries, or other equipment.

The wizard will reconfigure all of the devices on the connected Xanbus

network. If this is not what you want to do then do not proceed with the wizard.

Failure to follow these instructions can result in death or serious injury,

and/or equipment damage.

Figure 2-2 Warning Screen

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 129 130

Pas de commentaire

Schneider Electric Mupgrade Utility Guide d'installation Page 36