Schneider Electric Mupgrade Utility Guide d'installation télécharger pdf (Page 16)

Installing Conext Configuration Tool

975-0720-01-01 1–5

This manual is for use by qualified personnel only

Installing Conext Configuration Tool

To install Conext Configuration Tool, you will need to perform all of the following

steps:

1. Install the USB-to-Xanbus adapter driver software on your computer.

2. Connect the USB-to-Xanbus adapter to your computer.

3. Configure the USB-to-Xanbus adapter driver software.

Note: Perform step 3 before running Conext Configuration Tool for the first

time.

4. Connect the USB-to-Xanbus adapter to the Xanbus network.

5. Install the Conext Configuration Tool software on your computer.

Installing the USB-to-Xanbus Adapter Driver Software

Before you connect the USB-to-Xanbus adapter, you must install the driver

software.

To install the USB-to-Xanbus adapter driver software:

1. Insert the Installation USB flash drive into an available USB port on your

computer.

Note: Ensure that you are logged in with administrator privileges and that

Windows Explorer shows all file extensions.

2. Open Windows Explorer or equivalent file browser and navigate to the

Installation USB flash drive.

3. To start the installation process, double-click the file named

isCan Multidriver_v5.3.0002_Setup.exe.

4. Follow the step-by step instructions provided by the Windows InstallShield

Wizard.

5. When the installation is complete, click Finish.

6. Reboot your computer.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 129 130

Pas de commentaire

Schneider Electric Mupgrade Utility Guide d'installation Page 16