Schneider Electric Mupgrade Utility Guide d'installation télécharger pdf (Page 120)

Starting Firmware Upgrade

975-0720-01-01 5–3

This manual is for use by qualified personnel only

To upgrade Conext Configuration Tool firmware:

1. Power down Xanbus devices that are not intended to be updated. This

reduces network traffic and speeds up the update process.

2. Click Firmware Upgrade.

3. A warning box appears, as shown below.

Upgrading the firmware causes all devices to stop power conversion and

enter standby mode as a safety feature. Power conversion can be resumed

after the upgrades are complete.

To proceed with the firmware upgrade, click OK.

4. Select the folder that contains your saved firmware files, for example

C:\User\AppData\Roaming\CnxtCfgTool\Firmware. For more information, see

“Downloading Firmware Files” on page 5–2.

Note: Firmware files are listed in order of their version number (oldest to newest).

If a file is more recent than the device’s version, it is automatically selected. If you

would prefer to load a previous version of the firmware, or reload your current

version, select the appropriate check box.

To proceed upgrading your selection of files for devices, click Upgrade. If you

have selected an older firmware version, a warning message prompts you to

proceed.

Figure 5-2 Firmware file versions

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 129 130

Pas de commentaire

Schneider Electric Mupgrade Utility Guide d'installation Page 120