Schneider Electric ALTIVAR 58 TRX Guide d'installation télécharger pdf (Page 51)

VVDED397047USR6/03 Chapter 2—Menus

06/2003 3—Drive Menu

PG Type ★ PGt

Defines the type of sensor used

when an encoder feedback I/O

card is installed.

INC-DET DET

INC: incremental encoder (A, A+, B, B+ are wired).

DET Detector (only A is wired).

Num. Pulses ★ PLS

Defines the number of pulses for

each revolution of the sensor.

1 to 1024 1024

Table 11: 3—Drive Menu Parameters (continued)

Parameter Code Description

Adjustment

Range

Factory

Setting

[1]

Depending on the position of the 50/60 Hz switch. Ensure that the switch setting

matches the input frequency (see page 14).

[2]

= drive controller constant torque output current rating shown on the drive controller

nameplate.

[3]

The factory setting depends on the macro-configuration used: No for Material

Handling, Yes for General Use and Variable torque.

[4]

This parameter is not available on 125–500 hp drive controllers.

[5]

Refer to the drive controller instruction bulletin, VVDED397048US, for duty cycle

ratings of the drive controllers.

★ These parameters are available only with the I/O extension card installed.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 125 126

Pas de commentaire

Schneider Electric ALTIVAR 58 TRX Guide d'installation Page 51