Schneider Electric ALTIVAR 58 TRX Guide d'installation Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 126
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
© 1998–2003 Schneider Electric All Rights Reserved
VVDED397047USR6/03 Chapter 1—Overview
06/2003 Keypad Display
15
Function of Keys and Meaning of Displays
Figure 4 shows the front of the keypad display. The keys and displays
are explained below.
Figure 4: Front View of Keypad Display
LOC
PROG
LOC PROG
ESC
ENT
RUN
FWD
REV
STOP
RESET
Flashing display: indicates the selected
direction of motor rotation.
Fixed display: indicates the actual
direction of motor rotation.
Indicates the keypad display command
mode.
Appears in setup and programming
mode. Flashing display indicates that a
parameter has been modified but not
saved.
Four 7-segment backlit LCD: displays numerical
values and codes
16-character backlit LCD display: display of
messages in plain language
Press to move within the menus or among the parameters,
and to scroll a numeric value up or down.
Press to return to the previous menu, or to abandon an
adjustment in progress and return to the original value.
Press to select a menu, or to validate and save a choice.
If command by the keypad display has been selected
(parameter LCC in the 4—Control menu, set to YES) the
following buttons become active and only function in this
mode:
Press to change the direction of motor rotation.
Press to start the motor.
Press to stop the motor or reset a fault. The STOP
function can also stop the drive controller in terminal
command mode if so configured (see page 57).
ESC
ENT
FWD
REV
RUN
STOP
RESET
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 125 126

Commentaires sur ces manuels

Pas de commentaire