Schneider Electric Altivar 32 Manuel d'installation télécharger pdf (Page 12)

Hardware Setup

S1A28702 05/2010

Hardware Presentation

The following figure presents the DeviceNet module:

Firmware and EDS Version Compatibility

Only VW3 A3 609 option cards, with minimum 1.1IE01 firmware version, are compliant with ATV32.

NOTE: Check the firmware version, on the packaging label (on the right part of the label).

The associated EDS is the following SE_DN_ATV32_0101E.eds. This file is available on

www.schneider-electric.com.

Installation

Check that the card catalog number marked on the label is the same as that on the delivery note corresponding

to the purchase order.

Remove the communication module from its packaging and check that it has not been damaged in transit.

CAUTION

RISK OF DAMAGE TO THE DRIVE

Install only communication modules designed for ATV32. See references in the catalog.

Failure to follow these instructions can result in equipment damage.

DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH

Read and understand the precautions in “About the Book” on page 6 before performing the procedure in this

section.

Failure to follow these instructions will result in death or serious injury.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 87 88

Pas de commentaire

Schneider Electric Altivar 32 Manuel d'installation Page 12